45133ChoiceALERTChoiceALERT™Control all Sensors & accessories from one location™Wireless Alarm SystemWater Leak SensorUser’s Manual
1011 reinstall batteries. This returns the Control Center to standard operation mode.Note: The Control Center will automatically return to standar
1011 WARNING!Risk of personal injury- Prolonged exposure to alarm siren may cause permanent hearing lossBattery Warning!- Remove batteries before s
1213Water Leak Sensor F.A.Q.’SQ. I bought a new Sensor and the Control Center will not recognize it. Why?A. First, make sure the yellow battery isol
1213Q. Why does one of my Zones continually flash?A. This can be caused by 1 of 2 conditions. First condition, if it is a rapid flash it means a Sens
1415FCC WarningAny unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal la
1415WARNINGLimitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly,
is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, O
23Important Safeguards 4Introduction 4-5Installation 6Assigning a Sensor to a Zone 7-8Erasing a Sensor from a Zone 8-9Testing a Sensor or
23Before connecting or operating the Water Leak Sensor, please read these instructions carefully and save this manual for future reference.Congratulat
45Important safeguardsPre Cautions1. Do not attempt to disassemble the Water Leak Sensor, unless described in the user’s manual. There are no user ser
45When water is detected, the Sensor will transmit a signal to the Control Center. The settings on the Control Center determine if an alarm, alert or
67Preparing the Water Leak Sensor for InstallationThe Water Leak Sensor is composed of two sections linked together with a cable The Sensor (transmitt
67Note: If postioning the probe to a metal surface, ensure the Probe’s contacts do not touch the metal surface.Next, stretch the cable vertically and
89 Step 2 – Press the Zone button (1, 2, 3 or 4) for the Zone you want to assign to the Water Leak Sensor. The LED indicator for that Zone will
89 and the Zone LED indicator will flash twice. Step 3 - Release all buttons. The Zone has been erased.Note: The Zone/Sensor cannot be erased if:-
Comments to this Manuals